Book Online

All health funds accepted · Payment plans available, humm from $0 deposit · CDBS bulk billing

All health funds accepted · Payment plans available, humm from $0 deposit · CDBS bulk billing

Book online

A treatment room at Lumi Dental with timber cabinetry

THE LUMI BLOG

Bonded or cemented: how a crown is held on

Clinical studies of crown cements show similar results for full crowns either way, while onlays and partial crowns appear to depend more on how carefully they are bonded.

Dr James Tran, dentist at Lumi Dental Melrose Park

Dr James Tran

November 18, 2026 · Patient Education · 9 min read

For a full crown, research so far has not found that the type of cement makes a clear difference to how long the crown lasts. The choice may matter more for restorations that cover only part of the tooth, such as onlays and partial crowns, which rely more on the bond to hold them on. Your dentist's choice usually follows from the crown material, the shape of the prepared tooth and how dry the area can be kept.

This article explains the two broad ways a crown is fixed, what clinical studies have compared, and where the evidence is still thin.

Two ways of holding a crown on

Older cements, such as zinc phosphate and glass ionomer, fill the tiny gap between the crown and the tooth but rely mostly on mechanical retention. The crown stays on largely because its inner walls fit closely against the walls of the prepared tooth, so friction and shape do much of the work. Glass ionomer can also form a chemical bond with tooth structure, and it releases fluoride. Resin cements behave differently. They can bond to the tooth through micromechanical and chemical adhesion, and with the right surface treatment they also bond to the inside of the crown (Leung and colleagues, Dental Journal, 2022).

Within resin cements there are two main groups. Conventional resin cements are used with a separate adhesive, and sometimes an acid etch first. Self-adhesive resin cements, first sold in the early 2000s, are designed to bond without a separate adhesive or etchant, which saves steps (Leung and colleagues, 2022). Dentists often call fitting a crown with a resin cement "bonding" and fitting it with an older cement "cementing", but self-adhesive resin cements sit between the two, so the line is not sharp.

For full crowns, studies so far report similar results either way

A systematic review for the American Academy of Fixed Prosthodontics gathered 17 clinical studies of 2,436 zirconia and lithium disilicate (e.max type) crowns on natural teeth. Survival ranged from 83.3% to 100% for bonded zirconia crowns and from 82.0% to 100% for conventionally cemented ones. Bonded lithium disilicate crowns ranged from 83.5% to 100%, and conventionally cemented ones were reported at 98.5%. Average follow-up ranged from about two to ten years. The authors judged the two approaches comparable, while noting that the quality of the evidence was poor (Maroulakos and colleagues, Journal of Prosthetic Dentistry, 2019).

Later studies point the same way, although they are not randomised trials. In a retrospective study from Seoul of 288 full-coverage zirconia restorations on teeth and implants, resin-modified glass ionomer cement was non-inferior to a self-adhesive resin cement for keeping crowns in place. Only one crown, an implant crown, came loose, after four and a quarter years (Pyo and colleagues, Journal of Dentistry, 2023). Two University of Toronto studies of 40 and 210 lithium disilicate crowns, placed by dental students with one of two resin cements, found no significant link between the cement used and how long the crowns lasted (Aziz and colleagues, Journal of Esthetic and Restorative Dentistry, 2019; Journal of Prosthetic Dentistry, 2022).

The authors of the Seoul study noted that both cements have advantages on teeth and implants with favourable shapes. A crown on a tall, well-shaped tooth has a lot of mechanical grip. A crown on a short tooth has less, and that is one situation where a resin cement is suggested even for metal and metal-ceramic crowns (Leung and colleagues, 2022).

A treatment room at Lumi Dental with a 3D scan of the teeth on the screen
A 3D intraoral scan of the teeth on screen in a Lumi treatment room.

Partial coverage may depend more on the bond

An onlay or partial crown keeps more natural tooth, but it has much less wall to grip. Here, long-term trials from one research group have found differences between fitting methods.

A randomised split-mouth trial from the University of Regensburg compared three ways of fitting milled ceramic partial crowns. After a median of 12.2 years, estimated survival was 36.4% with a self-adhesive resin cement alone, 60.7% with a universal adhesive and a conventional resin cement, and 80.8% when the enamel was also etched first. Survival with the self-adhesive cement alone was significantly lower than with either of the other two methods (Pfister and colleagues, Dental Materials, 2026). The two methods that used a separate adhesive did not differ significantly from each other. Only 16 of the original 48 patients could be examined at 12 years, so the survival figures also draw on patient records, and all three methods used one manufacturer's products.

A second Regensburg trial used the same self-adhesive cement on partial crowns, with or without etching the enamel first. At 15 years, estimated survival was 78.1% with etching and 42.9% without, a significant difference, although only 19 of the 43 patients could be examined at the final review (Pfister and colleagues, Journal of Adhesive Dentistry, 2023). At three years the gap in this trial had not been statistically significant (Federlin and colleagues, Clinical Oral Investigations, 2014), and a meta-analysis of two shorter-term trials also found no significant difference (Solon-de-Mello and colleagues, Journal of Esthetic and Restorative Dentistry, 2019). Differences in fitting technique may take many years to show.

Thin ceramic is the other reason bonding matters. Porcelain veneers and other glass-ceramic restorations are usually fitted with resin cement, and light-cured or dual-cured cements are suggested over self-cured ones for ceramic thinner than 2 mm (Leung and colleagues, 2022). Our article on e.max crown thickness looks at how bonding and thickness interact in laboratory and clinical studies.

Sensitivity after the crown is fitted

Two small randomised trials compared sensitivity after crowns were cemented on teeth with a live nerve. In a trial of 88 crowns, teeth fitted with a self-adhesive resin cement had lower sensitivity scores at several follow-up visits over three weeks than teeth fitted with a resin-modified glass ionomer cement (Blatz and colleagues, Clinical Oral Investigations, 2013). In a trial of 50 patients, sensitivity was similar straight after cementation, but higher with glass ionomer at seven days (Shetty and colleagues, Journal of Contemporary Dental Practice, 2012). Both trials were short and small and each tested particular products, so they suggest a possible trend rather than a rule. If a crowned tooth stays sensitive, our article on sensitivity after a crown covers the usual causes.

Why your dentist may choose one over the other

Resin bonding is not automatically the better choice. Conventional resin cements cost more, are more sensitive to technique, take longer to use, and the excess is harder to clean away. Resin cements also need the tooth kept dry, and where that cannot be achieved another cement may be the better option (Leung and colleagues, 2022). A margin that sits deep under the gum can be hard to keep dry, and this is one reason a dentist may first raise the margin with deep margin elevation before an onlay is bonded.

The material matters too. Resin bonding has long been the standard for silica-based glass ceramics, while high-strength ceramics such as zirconia need their own surface pretreatment and primers or cements containing special adhesive monomers if they are to be bonded (Blatz and colleagues, Journal of Dental Research, 2018). Our article on how zirconia crowns are bonded explains this in detail.

In practice, the choice usually depends on:

  • the material: glass ceramics such as e.max, zirconia, metal or gold
  • how much of the tooth is covered: a full crown, an onlay or a veneer
  • how tall the prepared tooth is
  • whether the edge of the preparation can be kept dry during fitting

For dentists: the luting protocol may matter most on partial coverage

For full-coverage zirconia and lithium disilicate crowns on teeth with good retention form, the clinical data do not show a survival advantage for adhesive over conventional cementation, although the evidence is of poor quality and mean follow-up ranged from about two to ten years (Maroulakos 2019). In the retrospective Pyo 2023 series, RMGIC was non-inferior to self-adhesive resin cement for retention of zirconia restorations on teeth and implants. Where isolation of a deep margin is doubtful, a conventional cement on a retentive full crown is a defensible choice (Leung 2022).

For partial-coverage ceramics, the Regensburg trials suggest that a self-adhesive cement used alone is the weakest option over the long term, and that selective enamel etching was associated with higher survival with that cement at 15 years (Pfister 2023), as was a universal adhesive with a conventional resin cement at 12 years (Pfister 2026), where additional enamel etching gave no further significant gain. The limits are real: one research group, one manufacturer's materials, older feldspathic CAD-CAM blocks and student operators in the 15-year trial, high loss to follow-up, no significant difference at three years or in the two-trial meta-analysis, and no long-term clinical data on bonding partial-coverage zirconia (Blatz 2018).

Crowns and onlays at Lumi

Lumi Dental provides crowns and onlays and uses e.max (lithium disilicate), with zirconia offered as a choice. For bonded indirect restorations, we use OptiBond FL as our standard adhesive for immediate dentine sealing. The practice has a 3D intraoral scanner and an in-house lab. You can read more on our crowns and bridges page.

Questions about how crowns are fixed

Is a bonded crown less likely to fall off?

For full crowns, the clinical studies so far report similar survival with bonding and with conventional cements, although the evidence is limited. For onlays and partial crowns, long-term trials from one research group favoured fitting methods that include a separate adhesive or enamel etching. If a crown does come loose, keep it and see our guide on what to do when a crown falls off.

Can I ask which cement will be used?

Yes. Your dentist can explain why a particular cement suits your tooth and material. The answer often comes down to the shape of the tooth and how dry the edge can be kept.

Does the cement show?

Cement sits in a very thin layer under the crown. With ceramic restorations, the type, shade and thickness of a resin cement, together with the shade of the ceramic, can influence the final colour (Heboyan and colleagues, Molecules, 2023). This is one of the things your dentist considers when choosing a cement for visible teeth.

To talk through a crown or onlay, book a consultation at Lumi Dental in Melrose Park.

Sources

  • Leung GK, Wong AW, Chu CH, Yu OY. Update on dental luting materials. Dental Journal (Basel), 2022. PubMed 36354653
  • Maroulakos G, Thompson GA, Kontogiorgos ED. Effect of cement type on the clinical performance and complications of zirconia and lithium disilicate tooth-supported crowns: a systematic review. Journal of Prosthetic Dentistry, 2019. PubMed 30885580
  • Pyo SW and colleagues. Comparison of the clinical outcomes of resin-modified glass ionomer and self-adhesive resin cementations for full-coverage zirconia restorations. Journal of Dentistry, 2023. PubMed 37230241
  • Aziz A and colleagues. Clinical performance of chairside monolithic lithium disilicate glass-ceramic CAD-CAM crowns. Journal of Esthetic and Restorative Dentistry, 2019. PubMed 31565848
  • Aziz AM and colleagues. Clinical performance of CAD-CAM crowns provided by predoctoral students at the University of Toronto. Journal of Prosthetic Dentistry, 2022. PubMed 33423821
  • Pfister JL and colleagues. Randomized split-mouth clinical trial of CAD-CAM partial ceramic crowns luted with a self-adhesive resin cement or with a conventional resin cement combined with a universal adhesive after 12 years. Dental Materials, 2026. PubMed 41402152
  • Pfister JL and colleagues. Partial ceramic crowns luted with a self-adhesive resin cement with or without selective enamel etching: long-term results after 15 years. Journal of Adhesive Dentistry, 2023. PubMed 37800873
  • Federlin M, Hiller KA, Schmalz G. Effect of selective enamel etching on clinical performance of CAD/CAM partial ceramic crowns luted with a self-adhesive resin cement. Clinical Oral Investigations, 2014. PubMed 24407551
  • Solon-de-Mello M and colleagues. Longevity of indirect restorations cemented with self-adhesive resin luting with and without selective enamel etching: a systematic review and meta-analysis. Journal of Esthetic and Restorative Dentistry, 2019. PubMed 31207007
  • Blatz MB and colleagues. Postoperative tooth sensitivity with a new self-adhesive resin cement: a randomized clinical trial. Clinical Oral Investigations, 2013. PubMed 22782256
  • Shetty RM and colleagues. Comparative analysis of postcementation hypersensitivity with glass ionomer cement and a resin cement. Journal of Contemporary Dental Practice, 2012. PubMed 22918005
  • Blatz MB and colleagues. The effect of resin bonding on long-term success of high-strength ceramics. Journal of Dental Research, 2018. PubMed 28876966
  • Heboyan A and colleagues. Dental luting cements: an updated comprehensive review. Molecules, 2023. PubMed 36838607
Dr James Tran, dentist at Lumi Dental, Melrose Park

Written by Dr James Tran

Dr James Tran (BDent, University of Sydney; Graduate Diploma in Oral Implants) is a general dentist at Lumi Dental in Melrose Park. The team writes these articles to give clear, evidence-based dental information to help you make informed decisions about your care.

Inside Lumi Dental, Melrose Park

New patients

Your first visit is $149

A full 60 minute first visit with a check-up, clean, X-rays and a treatment plan. Usually $654, offer ends 31 December 2026. With most health funds there is no gap.

Open Monday to Saturday, and until 9:30pm on Thursdays. Free undercover parking at Melrose Central.